BorMann Elite BTW3500 - Installation Steps; Electrical Safety Checks; Installation Procedure; Installation Safety Warnings

EN
WWW.NIKOLAOUTOOLS.GR
4
3.Checking: the grounding is in compliance with safety regulaons or not, the outside leading wire of the machine is in
compliance with electrical safety regulaons or not.
Installaon steps
1. According to the screw holes' size of the machine hanging plate, drill holes in the corresponding posion of the installaon.
Fix and install the machine hanging plate, put the machine on and pull it down slightly, then the machine will rmly hang on its
mounng posion.
2.Use suitable water inlet pipe access to cold water port, make it connected or connect to a water switch, and ensure no leaking.
3.Connect corresponding bath apparatus on the heang water outlet of the machine.
4.Connect the earth wire and electric input line of the machine.
Installaon security warnings
1. The technicians who will install the appliance must be accordingly qualied.
2. All materials must comply with the relevant technical requirements.
3. Installaons must comply with the local installaon safety requirements and technical specicaons (grounding).
NOTICES:
1. Regular security checks should be done by relevant technicians.
2. Replace the shower head regularly, or clean it to make sure it remains unblocked.
3. Clean the dirt which is brought by the water inlet regularly in order to keep the inlet unblocked.
4. The appliance must be turned o should you observe any "abnormal" operaon. Ask the relevant technician to get the
appliance tested and maintain it.
WARNINGS:
1. ONLY QUALIFIED TECHNICIANS (ELECTRICIANS) MUST INSTALL THE APPLIANCE.
2. The installaon of the appliance must comply with all relevant technical requirements.
3. Good grounding measures must be ensures at all cases.
4. Spraying the appliance and auxilliary parts directly with water is STRICTLY FORBIDDEN.
5. FOLLOW STRICTLY THE INSTRUCTIONS in order to use and maintain the appliance with safety.
6. If the power line is damaged, in order to avoid danger, the special power line provided by the manufacturer must be used to
replace the damaged. All relevant work must be carried out only by relevant technicians.