BorMann Elite BTW3500 - Basic Instructions; Basic Functions; Using the Appliance; Installation Tools and Materials

EN
WWW.NIKOLAOUTOOLS.GR
3
Basic instrucons
Basic Funcons
1. The instant water heater is equipped with leakage protecon. When a leakage occurs, the appliance automacally cuts o
the heang output in order to ensure safety.
2. Overheang protecon: when the outlet water temperature is more than 50
o
Celsius, the appliance will automacally
interrupt the heang procedure in order to prevent burns or injuries.
3.
The heating protection does not function during icing conditions: when the temperature drops excessively (0-2 degrees
Celsius), the appliance will not be heang.
4. Dry burning-resistant protecon.
Using the appliance
1. Aer conrming that the water heater is installed properly, let the water in and close the water inlet valve when water comes
out from the water outlet.
2. Close the switch with which you have turned on the water heater. At this me a beeping sound comes from the buzzer.
3. Press ON/OFF to turn on the water heater switch. The display screen lights up. At this me, the outlet water temperature can
be set by pressing the UP/DOWN buon. Every me you press the UP buon, the temperature rises by one degree. Everyme
you press the DOWN buon, the temperature falls by one degree - to a minimum.
4. Aer seng the outlet temperature, open the inlet valve and the water heater enters into the heang state. The temperature
displayed on the display screen rises gradually unl it reaches the set point and maintains. When the water ow is too large, it
must adjusted in order to achieve the set outlet temperature. When the water ow is on the contrary inadequate, the appliance
will stop the heang procedure as the water ow will be required to be adjusted accordingly. The appliance has the funcon of
overheated protecon. When the outlet water temperature exceeds 50
o
Celsius, the instant water heater will stop the heang
procedure. If the water temperature drops to a certain temperature, the appliance will automacally return to the previous
heang procedure.
5. By closing the water inlet valve, the water heater will stop heang. The appliance is also characterized by a memory funcon.
When the water inlet valve is opened again, the appliance will automacally enter in the working state as previously without
any readjustment. The appliance is very convenient to use, in general.
Installaon
1. Tools required: percussion drill, hammer, cross screwdriver, wrench, pliers.
2.Materials: wires, matching leakage switch or suitable and safety wiring tools, insulaon packing materials, water pipe ngs,
water pipe sealing materials.
Wall mounted bathroom-kitchen-wash basin
electric, single phase, instant water heater
6 kW
TEMPERATURE DISPLAY
UP (TEMP.)
OFF/ON
WATER INLET
WATER OUTLET
Yellow/green Blue Brown
ELCB: Light is ON = Normal/Safe Operaon
ELCB: Light is ashing = Electric leakage detected
ELCB
HEAT
HEAT: Light is ON = The water is being heated
HEAT: Light is OFF = No heang is taking place
Fig. 1 Instant water heater
DOWN (TEMP.)