EasyManua.ls Logo

Börner TrendLine V3 - Safety and Safe Usage; Important Safety Warnings; Using the Safety Holder; Slicing with the Slice Insert

Börner TrendLine V3
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UK
Important Safety Suggestions
Caution. The metal blades are very sharp!
Please take great care when using your V-Slicer. Only touch
the plastic parts. Never touch the very sharp blades. For your
safety always use the Safety Holder. Never allow children to
touch or play with the V-Slicer. Always store the V-Slicer out of
reach of children and, if you prefer, purchase the Insert box.
Always use the Safety Holder (B)!
Safety Holder
Usable with every Börner slicer
Attention: Incorrect use of the Safety Holder may
result in injury and will damage the blades of your
V-Slicer. The unique design of the Safety Holder
allows you to safely slice fruits and vegetables with
precision and virtually no waste, while protecting
your fingers from the sharp metal blades.
If necessary, peel the fruit before slicing. Put
onions, cabbage, etc. with root ends into the
holder first, so that the button on top is pushed
up. Large fruits or vegetables must be halved or
quartered before putting into the holder. Slide
the holder continuously with light pressure in the
direction of the arrows down past the V-blades
and back up again. When the fruit is cut to the
holder, push down the button on top of the
holder and cut the rest of the fruit.
Slice Insert
This insert can be used on both sides.
Thick slicing
Use the Slice Insert (C1) with side marked ”thick“
facing upwards. Slide insert into V-Frame (A) until
it clicks into place. Place food onto prongs of the
Safety Holder (B). Using light pressure, slice with
a continuous down and up motion. Slices will fall
underneath the V-slicer.
Thin slicing
Use Slice Insert (C2) with side marked “thin“
facing upwards. Slide insert into V-Frame (A).
Place food onto prongs of the Safety Holder (B).
Using light pressure, slice with a continuous down
and up motion. Slices will fall underneath the
V-slicer.
C2
C1

Related product manuals