Bort BAC-500-22 - Safety Instructions

8
• Cold ashes from chimneys, wood/coal ovens, ashtrays
or grills.
• Coarse dirt of all types, such as sand or rubble.
Note: The amount that can be vacuumed up can vary de-
pending on the vacuuming material.
Use the ash/dry vacuum cleaner only with:
• Original spare parts, accessories and special accessories.
The manufacturer is not responsible for any damages that
may occur on account of improper use or wrong opera-
tions.
Continuously check hoses and vacuum cleaner for heat
while vacuuming ashes.
Do not vacuum up soot or ammable substances.
The vacuumed material must not exceed a temperature
of 40 °C.
In order to avoid the collection of materials that may rep-
resent a re risk (e.g. sawdust): Open, empty and clean
the vacuum cleaner outside before and after vacuuming
ashes.
SAFETY INSTRUCTIONS
• This appliance is not intended for use by persons
with limited physical, sensoric or mental capacities or
lack of experience and/or skills, unless such persons are
accompanied and supervised by a person in charge of
their safety or if they received precise instructions on the
use of this appliance.
• Children must only use this appliance if they are older
than 8 and if they are supervised by a person responsible
for their safety or if they are instructed on the use of the
appliance by such person.
• Keep packaging lm away from children - risk of
suocation!
• Switch the appliance o after every use and prior to
every cleaning/maintenance procedure.
• The appliance may not be used in areas where a risk of
explosion is present.
• The ash and dry vacuum cleaner must not be used for
the separation of hazardous substances.
• Only ashes from permissible fuels (e.g. natural wood,
wooden briquets, wood pellets, lignite and hard coal)
must be vacuumed.
• Do not vacuum up soot.
• Vacuuming material which appears to have cooled
down from the outside may still be very hot inside. Hot
ash particles may ignite again in the air ow.
• Stir up the ashes with a metal object to check whether
the ashes are still hot.
• Please make sure that the oven is cold before you
vacuum clean ovens.
• Continuously check hoses and vacuum cleaner for heat
while vacuuming ashes. If you notice a temperature rise,
switch o the vacuum cleaner immediately. Pull out the
mains plug. Remove the vacuuming material from the
ash and dry vacuum cleaner. Allow device to cool down
ENGLISHGB
Ash vacuum cleaner
PRODUCT ELEMENTS (FIG. 2)
1. Switch;
2. Handle;
3. Botton section;
4. Metal clasp;
5. Alu nozzle;
6. HEPA lter;
7. Metal hose;
8. Tank;
9. Air inlet
THE COMPLETE SET INCLUDES
- HEPA lter;
- Metal mesh;
- Fire resistant hose;
- Aluminum tube
GENERAL NOTES
Dear Customer,
Please read and comply with these original in-
structions prior to the initial operation of your
appliance and store them for later use or subse-
quent owners.
Proper use
This appliance has been designed for use in private house-
holds and is not intended for commercial use.
• Protect the unit from rain. Do not store outside.
The ash and dry vacuum is especially suited for vacuum-
ing:
TECHNICAL SPECIFICATIONS (g. 1)
Voltage / Current frequency 220 V / 50 Hz
Noise level 80 db
Power consumption 900 W
Hose leghth 1 m
Cable length 2,5 m
Airflow 60 l/sec
Product weight 3,3 kg
Container
capacity
22 L