Need help?Do you have a question about the Bosch AquaStar 6.0L and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | AquaStar 6.0L |
| Capacity | 6 place settings |
| Child Lock | Yes |
| Delay Start | Yes |
| Dimensions (H x W x D) | 450 x 551 x 500 mm |
Important information on how to install, use and maintain the appliance.
Checking packaging for transit damage and correct appliance installation.
How to activate/deactivate door and button childproof locks.
Procedures for repair, disposal, and safety warnings concerning children.
Identifies components of the control panel with numbered references.
Lists numbered interior parts of the dishwasher.
How to set the amount of salt dispensed based on water hardness.
Table showing water hardness ranges and corresponding machine settings.
How to refill and use special salt in the dispenser.
Using detergents with salt component and switching off the indicator.
How to adjust the amount of rinse aid dispensed.
Switching off the rinse aid refill indicator.
Lists types of utensils that are not dishwasher-proof.
Causes of glass/utensil damage and recommendations for prevention.
Guidance on placing and removing utensils for optimal washing.
Placement of cups and glasses in the top basket.
How to adjust the top basket using levers or rollers.
Using less detergent for light loads and info on combination detergents.
Do not place small parts in tablet tray; avoid using tray as handle.
How to select a programme based on utensil type and soiling degree.
How test institutes can request conditions for comparison tests.
Reduces running time by 20-50% at increased consumption.
Saves water, energy, and time when washing small loads.
Increases temperature for enhanced hygiene, ideal for baby bottles.
Intensified spray pressure for heavily soiled items in lower basket.
Increased temperature and drying phase for better plastic part drying.
Consumption values, sensor function, and how to start the appliance.
Symbols indicating cleaning, rinsing, and drying stages.
Indicates the remaining time of the selected programme.
Allows delaying program start in 1-hour steps up to 24 hours.
Programme ends when 0:00 is indicated on the display.
Appliance switches off automatically after 1 minute by default.
Steps to switch off the appliance and turn off the tap.
How to pause and save a programme by switching off the appliance.
How to cancel a running programme using the START button.
Programme cannot be changed after START; requires cancel and restart.
Final rinse at higher temperature to improve drying results.
Check spray arms for deposits; clean appliance with suitable detergents.
Check refill indicators and refill salt and/or rinse aid if required.
How to check, clean, and re-install the filter system.
Checks for fuse, plug, or door issues.
Covers door lock, child lock, dispenser closure, and residue problems.
Covers "Check water supply" error and causes.
Covers blocked supply, water remaining, foam formation, and appliance stopping.
Covers valve noises and knocking/rattling during rinsing.
Improper loading, low detergent, blocked spray arms/filters.
Detergent bleaching or rinsing temperature issues.
Caused by detergent type, water hardness, or incorrect settings.
Unsuitable detergent or glasses not dishwasher-proof.
Too much rinse aid or plastic parts discolouration.
Cutlery not rust-resistant or high salt content.
Early door opening, no drying program, or poor drying performance.
Correct connection for function, electrical load, and safety.
Power supply, protective conductor, cord replacement, unit securing.
Appliance check, water stains, weight, voltage, load, fuse, pressure, inlet, temperature.
Connecting the waste-water hose to the siphon.
Connecting the fresh-water hose to the tap.
Required water pressure and minimum inlet rate.
How to enable and adjust the hot water setting.
Sorting and disposing of plastic packaging materials.
Information on WEEE directive for old appliance disposal.
To Next Page