en-us Faults – what to do?
32
Water dispenser
--------
Ice maker
--------
The water dispenser is not functioning.
No water supply. Check water connection and contact technician if necessary.
Low water pressure. Only connect appliance to lines with sufficient water pressure.
Kink in water hose. Turn off water supply, straighten out kink. Replace water hose, if nec-
essary.
The water filter is blocked or needs to be replaced. Replace water filter.
Water is leaking out of the appliance.
Water connection is not tight. Check if the connections are fastened firmly and the water hose is
undamaged.
If the water hose is damaged, contact customer service and have it
replaced. Replacement must be performed by customer service or a
similarly qualified person only.Use original parts supplied by the man-
ufacturer only.
The ice maker is not functioning.
Ice cube production has been switched off. Switch on ice cube production.
The freezer compartment is too warm. Set the temperature lower.
~ "Operating the appliance" on page 20
The water filter is blocked or needs to be replaced. Replace water filter.
No water supply. Check water connection and contact technician if necessary.
Ice maker without power. Please contact customer service.
~ "Customer service" on page 33
Ice cube production is low or misshapen.
After switching on or removing many ice cubes, there will be too few
in the ice cube bin.
It takes around 48 hours for an empty ice cube bin to fill up.
Ice cube production stops even though the ice cube bin is not yet full. Do not store the ice scoop on the ice in the ice cube bin. Otherwise the
sensor will not detect the actual fill level of the bin.
Freezer compartment is too warm. Set the temperature lower.
~ "Operating the appliance" on page 20
Low water pressure. Only connect appliance to lines with sufficient water pressure.
To Next Page
Loading...
Need help?
General
