EasyManua.ls Logo

Bosch BC016 - Extension Cords

Bosch BC016
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-3-
Extension Cords
• AN EXTENSION CORD SHOULD NOT BE USED
UNLESS ABSOLUTELY NECESSARY.
Use of
improper extension cord could result in risk of fire
and electrical shock. If an extension cord is used,
make sure:
a. The pins on plug of extension cord are the same
number, size, and shape as those of plug on charger.
b. The extension cord is properly wired and in good
electrical condition.
c. The wire size is large enough for AC ampere rating
of charger as specified below:
d. An extension cord is a temporary solution. Move
the charger to a standard receptacle as soon as the
job has been completed.
Length of
Cord, Feet
25 50 100 150
AWG Size
of Cord
18 16 16 14
Extension Cord Chart for 220/240 Volt Tools:
0.75mm
2
CORD 50 Meters
1.0mm
2
CORD 75 Meters
“SAVE THESE INSTRUCTIONS”
CHARGER
RED
LIGHT
GREEN
LIGHT
Plug charger cord into your standard power outlet,
then insert battery pack into charger. The charger’s
green indicator light will begin to “BLINK”. This
indicates that the battery is receiving a fast charge.
Fast-charging will automatically stop when the
battery pack is fully charged.
When the indicator light stops “BLINKING” (and
becomes a steady green light) fast charging is
complete, and an acoustical signal sounds for a
period of approximately 2 seconds which indicates
that the battery is completely charged.
The battery pack may be used even though the
light may still be blinking. The light may require
more time to stop blinking depending on
temperature.
The purpose of the green light is to indicate that
the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light will
stop blinking in less time if the battery pack was
not completely discharged.
When charging several batteries in sequence, the
charge time may slightly increase.
When the battery pack is fully charged, unplug the
charger (unless you're charging another battery
pack) and slip the battery pack back into the tool.
Charging Battery Pack
FIG. 1
This charger will only charge the
following batteries:
2 607 335 089, 2 607 335 090, &
BAT001 thru BAT039
Charge time: 15-26 min.

Related product manuals