Bosch BGL8PET2 - Cleaning the HEPA Hygiene Filter; Cleaning the Micro-Hygiene Exhaust Filter

Cleaning and servicing en
33
2. Unplug the mains plug.
3. Open the lid.
→Fig.
16
4. In order to release the motor pro-
tection filter from the catch mech-
anism, pull on the side tabs.
→Fig.
17
5. Remove the motor protection filter
in the direction of the arrow.
6. Tap out the motor protection filter.
7. If the motor protection filter is very
dirty, rinse it.
→Fig.
18
8. The filter must then be left to dry
for at least 24hours.
9. Care for the appliance and the ac-
cessory parts with a standard com-
mercially available plastic cleaner.
10.If required, vacuum the dust com-
partment using a second appli-
ance or clean it with a dry duster
or dusting brush.
11.After cleaning, refit the motor pro-
tection filter into the appliance.
12.Lock the motor protection filter into
place at the top.
13.Close the lid.
Cleaning the Micro-Hygiene
exhaust filter
1
Tip:To achieve the best possible va-
cuuming results, clean or replace the
Micro-Hygiene exhaust filter
1
once a
year. After vacuuming fine dust
particles, clean or replace the Micro-
Hygiene exhaust filter
1
in order to
guarantee the appliance's suction.
1. Switch off the appliance.
2. Unplug the mains plug.
3. Open the rear flap.
4. Push the locking tab in the direc-
tion of the arrow.
→Fig.
19
5. Unlock the filter holder.
6. Remove the foam filter
1
and the
Micro-Hygiene exhaust filter
1
from
the filter holder.
→Fig.
20
7. Tap out the foam filter
1
and the
Micro-Hygiene exhaust filter
1
.
8. If it is very dirty, wash the foam fil-
ter
1
and the Micro-Hygiene ex-
haust filter
1
.
→Fig.
21
9. Leave the foam filter
1
and the Mi-
cro-Hygiene exhaust filter
1
to dry
for at least 24 hours.
10.Insert the foam filter
1
and the Mi-
cro-Hygiene exhaust filter
1
into the
filter holder.
11.Insert the filter holder into the ap-
pliance.
12.Close the rear flap.
Cleaning the HEPA hygiene
filter
1
Note:The filtering action of the filter
remains intact, even if the filter sur-
face becomes discoloured.
Tips
¡ For optimum performance level,
clean the HEPA hygiene filter
1
once a year.
After vacuuming fine dust particles,
clean the HEPA hygiene filter
1
in
order to guarantee the appliance's
suction performance.
¡ To clean the filter unit thoroughly,
you can clean the filter unit in the
washing machine. To protect the
rest of the laundry, put the filter
unit into a laundry bag. Wash the
filter unit at 30°C using a gentle
programme and the lowest spin
speed.
1. Switch off the appliance.
1
Depending on the appliance specifications
Downloaded from www.vandenborre.be