18
If suction diminishes considerably, the dust bag
must be replaced, even if it is not yet full. In this case
it is essential to change the dust bag due to the type
of material it contains.
Turn the dust compartment locking lever in the
direction of the arrow to open the vacuum cleaner
lid.
Seal and remove the dust bag by pulling on the cover
clip
Replacing the dust bag
Insert the new dust bag in the holding fixture,
up to the stop.
Attention: Cover will only close if a paper filter is
inserted! After vacuuming fine dust particles
(e.g. cement, plaster, etc.), clean the motor filter
and replace the Microsan filter if necessary.
To Next Page
Loading...
