Bosch C10 - Safety; General Caution; Electrical Safety Warning; Fire and Explosion Hazard

Bosch C10 charger I Operating instructions EN
12
2 Safety
Please read these instructions carefully before using the charger.
I
CAUTION
 If the power supply cable is damaged, it must be replaced by the manufacturer or
service representative in order to avoid any danger.
 Disconnect the power supply before making or breaking the connections to the bat-
tery.
 The battery connection, which is not connected to the vehicle body, must be con-

black, away from the battery and fuel lines. Only then connect the battery charger to
the mains supply.
 -
connect the connection to the vehicle body (–) black and battery connection (+) red
in this order.
I
WARNING
The mains plug must not come into contact with water. Water must be prevented from

I
WARNING
Danger of explosion and re!
Explosive gases.
 
 Provide adequate ventilation during the charging process.
 Ensure that the area around the battery is well ventilated during the charging pro-
cess.
Battery
Use the battery charger only for 12 V 5 Ah-120 Ah lead-acid type (WET, EFB, GEL, AGM,
open and VRLA) batteries.
I
WARNING
Do not attempt to charge a non-rechargeable battery!