What to do if Power Charge 7000i Bosch Battery Charger does not respond?
If the Power Charge 7000i Bosch Battery Charger does not respond after plugging in the charging cable or after authenticating via the RFID system, please check the power supply on the building side.
What to do if the residual current protection device in Bosch Power Charge 7000i Battery Charger has been triggered?
If the residual current protection device in your Bosch Battery Charger has been triggered, perform a visual inspection of the product, charging cable, and vehicle. To reset it, disconnect the charging cable from the vehicle for about 4 seconds. Then, reconnect the charging cable; the charging process can then be requested by the vehicle.
What to do if the LED flashes blue 3x (on 10% / off 90%) on Bosch Power Charge 7000i Battery Charger?
If the LED on your Bosch Battery Charger flashes blue 3 times (on 10% / off 90%), it indicates a communication disturbance with the vehicle or that the maximum set current has been exceeded. Ensure the charging cable is correctly plugged into the vehicle. After a self-test corrects the fault, the LED will light up green, and the vehicle can request charging.
What does it mean if the LED flashes blue 3x (on 90% / off 10%) on Bosch Battery Charger?
If the LED on your Bosch Battery Charger flashes blue 3 times (on 90% / off 10%), it indicates possible over-voltage or under-voltage of the supply voltage. You don't have to intervene. After a self-test and the fault is corrected, the LED lights up green. The vehicle can request charging.
What does it mean if the LED flashes blue 6x (on 50% / off 50%) on Bosch Power Charge 7000i Battery Charger?
If the LED on your Bosch Battery Charger flashes blue 6 times (on 50% / off 50%), it indicates an internal disturbance of the product. Disconnect the charging cable from the vehicle and the product from the supply voltage by switching off the building-side line fuses. Wait about 1 minute, then turn the line fuse back on and reconnect the charging cable to the vehicle. After a self-test and the fault is corrected, the LED lights up green, and the vehicle can request charging.
What does it mean if the LED flashes blue 3x (on 50% / off 50%) on Bosch Power Charge 7000i Battery Charger?
If the LED on your Bosch Battery Charger flashes blue 3x (on 50% / off 50%), it indicates over-temperature. You don't have to intervene. After a self-test and the fault is corrected, the LED lights up green. The vehicle can request charging.
Defines signal words (DANGER, WARNING, CAUTION, NOTICE) for risk indication.
Provides essential installation and operation safety guidelines for users and electricians.
Warns about electric shock hazards and precautions before working on electrical components.
Emphasizes regular inspection and maintenance by qualified contractors for safe operation.
Provides crucial safety steps before and during charging system operation.
Details the process of mounting the Power Charge 7000i unit onto the wall.
Covers essential pre-operation checks like protective conductor and insulation tests.
Describes tests for short circuit and RCD tripping switch-off conditions.
Guides users on the steps required to successfully charge the vehicle.
Helps diagnose issues by correlating LED displays with specific faults and troubleshooting steps.
Presents a comprehensive table of technical specifications for the Power Charge 7000i.
General| Charging Current | 10A |
|---|---|
| Operating Voltage | 230V AC |
| IP Rating | IP65 |
| Weight | 1.2 kg |
| Battery Voltage | 12V |
| Protection | Short Circuit, Reverse Polarity |
| Compatible Battery Types | AGM, Gel |
| Charging Stages | 7-stage charging |
To Next Page