Installation (only for approved contractors)
Power Charge 7000i – 6721849906 (2022/11)
32
▶ Remove the respective electrical connections’ cap.
Fig. 34 Electrical connections’ cap
▶ Put the cable gland grommet and the cable gland multi-hole
(CLIXX) in the respective place.
Fig. 35 Cable gland grommet and the cable gland multi-hole
(CLIXX) installation
4.2 Mounting
To mount the Power Charge 7000i on the wall, proceed with
the following steps (Fig. 36, page 33):
▶ Mark the two top fixing holes on the top by placing the
wall-mounted bracket using a bubble level to alight it.
Make sure that the up arrow on the standpoint is upwards.
▶ Drill the two top fixing holes, insert two wall plugs and
mount the wall-mounted bracket using the two screws and
the two washers.
▶ Place the Power Charge 7000i shortly on the wall-mounted
bracket to draw the two bottom holes.
▶ Drill the two bottom holes.
▶ Guide the electrical cables through the hole.
▶ Insert two wall plugs and mount the Power Charge 7000i
on the wall using the two screws and the two washers.
This step is optional.
▶ Guide the cables for the interface connections through the
holes.
0010044539-001
0010044542-001
To Next Page
Loading...
