Inspection and maintenance
43
Power Charge 7000i – 6721849906 (2022/11)
6.1.5 Authentication via RFID card
The Power Charge 7000i has a security mechanism against
unauthorised access through a RFID system.
To teach in the RDFID card:
▶Open the app.
▶ Start the teach-in mode.
▶ Hold the RFID card in front of the RFID reader within
60 seconds.
Fig. 48 Authentication via RFID card
Status LED
Table 5 Status LED
7 Inspection and maintenance
7.1 Cleaning the Wallbox
NOTICE
Possible damage to the appliance!
To prevent any damage to the appliance:
▶ Make sure to no use aggressive cleaning agents
(e.g. petroleum ether, acetone, ethanol or methylated
spirit-based glass cleaner) when cleaning the Wallbox,
particularly the plastic surface.
▶ Make sure to use mild detergent solution (e.g. washing-up
liquid, neutral cleaner) and a soft, dampened cloth for
cleaning.
7.2 Protective devices
The following components (fig. 26, page 29) are protective
devices:
▶Housing
▶Charging cable
▶ Protective cover
▶Charging coupler
NOTICE
Possible damage to the appliance!
To prevent any damage to the appliance:
▶ Make sure to inspect the protective devices before every
charging process.
▶ Make sure to have a qualified electrician to perform the
electrical function tests at regular intervals in compliance
with the national regulations.
LED display Description
LED lights up purple RFID teach-in mode is active.
LED lights up green (5 sec.)
beep one time
RFID card has been
successful.
LED lights up green and beep
once
RFID card has been accepted.
LED lights up red (5 sec.)
beep 5 times short
RFID card has not been
accepted.
0010044563-001
HomeCom Easy
play
ANDROID APP ON
To Next Page
Loading...
