Operation
Power Charge 7000i – 6721849906 (2022/11)
42
6.1.2 Charging mode status
The status indicator (fig. 26, page 29) shows the charging
system operating status.
Table 3 Charging mode status
6.1.3 Standby and software update
Table 4 Standby and software update
6.1.4 Optional digital input
An optional external locking device can be connected to the
internal interface. In this case, the charging does not take place
until external enabling has been issued.
Fig. 47 Optional digital input
LED display Description
LED flashes white Booting up the product after switching it on.
LED lights up blue The product is ready for operation (condition A).
LED lights up yellow Product without release (state B) – external release input, RFID or app)
LED lights up green Product released and communication to vehicle established (condition B or C).
LED pulsates green & signal tone once The charging process has started (state C & actual current >2A).
LED pulsates slowly The charging process runs with a reduced charging current.
LED inactive The product is in standby.
LED lights u white, blue and
red alternately
The software is updating.
0010044549-001
EN
EN
EN
To Next Page
Loading...
