EasyManua.ls Logo

Bosch DIG97IM50 - Accessories; Installation Instructions

Bosch DIG97IM50
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Accessories en
9
10.1 Product number (E-Nr.) and production
number (FD)
You can find the product number (E-Nr.) and the pro-
duction number (FD) on the appliance's rating plate.
Depending on the model, the rating plate can be found:
¡ Inside the appliance (remove grease filters for ac-
cess).
¡ On top of the appliance.
Make a note of your appliance's details and the Cus-
tomer Service telephone number to find them again
quickly.
11  Accessories
You can buy accessories from the after-sales service,
from specialist retailers or online. Only use original ac-
cessories, as these have been specifically designed for
your appliance.
Accessories vary from one appliance to another. When
purchasing accessories, always quote the exact
product number (E no.) of your appliance. →Page9
You can find out which accessories are available for
your appliance in our catalogue, in the online shop or
from our after-sales service.
www.bosch-home.com
Accessories Order number
Clean Air Standard recir-
culation kit – narrow, 260
mm
DIZ1CG1I4
Clean Air Standard recir-
culation kit – wide, 345
mm
DIZ2CB1I4
Accessories Order number
Clean Air Standard odour
filter – narrow, 260 mm
DZZ1CX1B4
Clean Air Standard odour
filter – wide, 345 mm
DZZ2CB1B4
Clean Air Standard recir-
culation kit, external –
narrow, 260 mm
DSZ6220
Clean Air Standard recir-
culation kit, external –
wide, 345 mm
DSZ6230
Clean Air Standard odour
filter (replacement)
DSZ5201
Long Life odour filter
(need for replacement)
DZZ0XX0P0
12  Installation instructions
Observe this information when installing the appliance.
12.1 Scope of delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
12.2 Safety clearances
Comply with the safety clearances for the appliance.
For Australia and New Zealand the minimum safety
clearance above electrical cooktops must be 600 mm.

Related product manuals