12
Increases in time occur because of:
– additional rinse cycle if excessive foam is in the
laundry,
– multiple spinning if the laundry is distributed poorly
in the drum,
– increased heating times, e.g. when the water is too
cold,
– water pressure too low,
– selection of an additional option, e.g. Rinse Plus
' and/or Wash Plus È after the programme has
started,
– very absorbent washing extends the heating
duration,
– the laundry for drying is wet.
Finish in time You can select the finish in time, see page 33.
Drying duration or automatic
drying
You can set the drying duration or automatic drying by
touching the Dry ˆ
button, see page 29. When the
washing and drying without a break was selected, time
drying or auto drying duration will add in programme
duration automatically. Related programmes will
prolong 5-15 minutes for good washing performance.
Rinse cycles
On if there is (are) rinse cycle(s) with the selected
programme or “Rinse Plus '” was selected. The sym-
bol means “default rinse cycle(s) + selected
additional rinse cycle” by touching the “Rinse Plus '”
button.
To Next Page
Loading...
