56
Useful tools The following tools are helpful:
– Box wrench A/F 13 for removing the transportation
bolts.
– Spirit level for aligning the washer-dryer.
Dimensions a = 600 mm
b = 560 mm
c = 860 mm (WVD2452BGB)
c = 850 mm (other variants except WVD2452BGB)
Weight 67 kg
Installation surface Appliance stability is important so that the washer-dryer
does not "wander" during the spin cycles.
The installation surface must be solid and level. Soft
floor coverings, e.g. carpets or floor coverings with a
foam backing are not suitable.
If the washer-dryer is to be installed on a wooden floor:
■ If possible, install the washer-dryer in a corner.
■ Screw a water-resistant wooden board (at least 30
mm thick) to the floor.
■ Secure the washer-dryer feet with fixing brackets*.
If the washer-dryer is to be installed on a base:
■ Secure the washer-dryer feet with fixing brackets*.
* Holding brackets (set) can be obtained from a
specialist store or the Customer Service,
order no. WMZ 2200.
To Next Page
Loading...
