63
Transport, e. g. when
moving
Before transporting the washer-dryer:
– Turn off the tap.
– Reduce the water pressure in the water inlet hose
(refer to page 46).
– Drain any residual washing solution (refer to page
45).
– Disconnect the washer-dryer fror the mains.
– Dismantle the supply and drainage hose.
– Install transportation protection devices.
Having transported the appliance and ensured proper
installation and connection, allow the Empty
programme to run through before starting the first
wash programme.
Transporting the washer-dryer:
Preparing and inserting the
transport bolts
■ Remove the 4 covers C.
■ Remove the rear cover D and prepare the transport
bolts.
■ Insert and tighten the transport bolts.
To Next Page
Loading...
