Bosch exxcel - Water inlet and filter maintenance; Cleaning water inlet strainers; Cleaning the tap strainer; Cleaning the appliance strainer

47
Cleaning water inlet
strainers
This is necessary if very little or no water flows into the
washer-dryer.
First, reduce the water pressure in the inlet hose:
■ Turn off the tap.
■ Turn the programme selector to any programme
(except Spin Í/ Drain ).
■ Touch the Start/Pause P button, and allow the
programme to run for approx. 40 seconds.
■ Turn the programme selector to Off.
Cleaning the strainer at the
water tap
■ Disconnect the hose from the water tap.
■ Rinse the strainer under flowing water.
■ Connect the hose.
Cleaning the strainer on the
washer-dryer
■ Disconnect the hose from the back of the
washer-dryer.
■ Pull out the strainer and rinse under running water.
■ Insert the strainer and reconnect the hose.
■ Turn on the water tap and check whether water is
still discharged. If water is leaking, check that the
filter is correctly seated.
■ Turn off the tap.