49
Help with minor problems
If repairs are needed, and assuming that you cannot
eliminate the fault yourself with the aid the following
table:
■ Turn the programme selector to Off.
■ Disconnect the appliance from the mains.
■ Turn off the tap.
■ Call customer service, see page 54.
m Risk of electric shock!
Repairs may be carried out by customer service or
authorised technicians only.
Fault displays
Text in display field
and signal emitted
Possible cause Remedial action
F:16 Door not closed properly. Check whether laundry is trapped in door;
Close the washer-dryer door.
F:17 Tap not turned on. Turn the tap on.
Inlet hose kinked or pinched. Eliminate cause.
Filter blocked in water inlet hose. Clean filter, see page 47.
Water pressure too low. Eliminate cause.
F:18 Loose debris is blocking the pump. Clean the pump, see page 45.
Drainage pipe and/or drainage
hose blocked.
Clean drainage pipe and/or drainage hose.
There is too much residual water in
the drum when drying.
Stop the drying programme, select the “ Spin Í ”
programme before drying.
To Next Page
Loading...
