To Next PageTo Next Page
Need help?Do you have a question about the Bosch GBH Professional 18V-26 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| Impact Energy | 2.6 J |
| Max Drilling Diameter in Concrete | 26 mm |
| Max Drilling Diameter in Steel | 13 mm |
| Max Drilling Diameter in Wood | 30 mm |
| Weight | 3.6 kg |
| Tool Holder | SDS plus |
| Rated Speed | 0 – 890 rpm |
| No-load Speed | 0 – 890 rpm |
Read all safety warnings and instructions to prevent electric shock, fire, and injury.
Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Ensure proper plug matching, avoid body contact with earthed surfaces, protect from rain/wet, and do not abuse the cord.
Stay alert, use common sense, and wear protective equipment like eye protection and dust masks.
Prevent unintentional starting, do not overreach, dress properly, and keep hair/clothing away from moving parts.
Do not force the tool, use correct tool, maintain tools, and keep cutting tools sharp.
Recharge only with specified charger and do not use damaged batteries.
Machine is for hammer drilling in concrete, brick, stone, and light chiselling work.
Lists and describes the various components and features of the power tool.
Instructions for charging the lithium-ion battery pack using specified chargers.
Instructions for operating the machine with the auxiliary handle securely attached.
Guidance on adjusting the auxiliary handle to any position for a secure working posture.
Procedure to start the power tool by inserting the battery and setting the direction switch.
How to select the operating mode using the mode selector switch.
Adjusting the speed and impact rate by varying pressure on the On/Off switch.
Using EPC for slow start-up and reduced operating speed in sensitive materials.
Mechanism that interrupts drive if the tool insert becomes caught or jammed.
Feature providing better control by switching off the tool if it rotates unexpectedly.
Setting the desired drilling depth using the depth stop.
Locking the chisel in 44 positions for optimum working.
Procedure for inserting screwdriver bits using a universal bit holder.
Using the GDE 18V-16 accessory for extracting concrete and stone dust.
Keeping the machine and ventilation slots clean for safe and proper working.
Information on obtaining service, repair, and spare parts.
