To Next PageTo Next Page
Need help?Do you have a question about the Bosch Professional GBH 18V-26 and is the answer not in the manual?
General| Voltage | 18 V |
|---|---|
| Impact Energy | 2.6 J |
| Max Drilling Diameter in Concrete | 26 mm |
| Weight | 3.6 kg |
| Tool Holder | SDS plus |
| Drilling Diameter in Concrete with Hammer Drill Bits | 4 - 26 mm |
| Optimum Application Range in Concrete with Hammer Drill Bits | 8 - 16 mm |
| Max Drilling Diameter in Steel | 13 mm |
| Max Drilling Diameter in Wood | 30 mm |
| Tool Length | 347 mm |
| Impact Rate at Rated Speed | 0 - 4, 350 bpm |
| Rated Speed | 0 - 890 rpm |
| No-load Speed | 0 - 890 rpm |
| Impact Rate | 0 - 4, 350 bpm |
Read all safety warnings, instructions, illustrations and specifications.
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way.
Do not force the power tool. Use the correct power tool for your application.
Use suitable detectors to determine if there are hidden supply lines or contact the local utility company.
The power tool is intended for hammer drilling in concrete, brick and stone.
The numbering of the product features refers to the diagram of the power tool on the graphics page.
Noise emission values determined according to EN IEC 62841-2-6.
Charging the battery.
Protect the battery against moisture and water.
Do not operate your power tool without the auxiliary handle (19).
You can swivel the auxiliary handle (19) to any angle for a safe work posture.
Hammer drilling and chiselling require SDS-plus application tools.
Inserting/removing the keyed chuck.
Removing/inserting the quick-change chuck for GBH 18V-26 F.
Procedures for changing SDS plus and keyed tools.
Inserting SDS plus application tools.
Inserting the application tool into a keyed chuck.
Inserting the application tool into a keyless chuck.
The operating mode of the power tool is selected using the impact/mode selector switch (16).
The rotational direction switch (11) is used to change the rotational direction of the power tool.
To switch on the power tool, press the on/off switch (13).
You can adjust the speed/impact rate of the power tool when it is on by pressing in the on/off switch (13).
You can lock the chisel in 36 different positions for optimal working.
You can use the depth stop (20) to set the required drilling depth X.
If the application tool jams or snags, the power transmission to the drill spindle will be interrupted.
The rapid shut-off function gives the user greater control over the power tool.
EPC assists when drilling in sensitive materials by ensuring slow start-up.
Only apply the power tool to the screw/nut when the tool is switched off.
Remove the battery from the power tool before carrying out work on the power tool.
Our after-sales service responds to your questions concerning maintenance and repair of your product.
