10
EURO • Printed in USA • BA 3 609 929 557 • GKS 75S/85S • GB • OSW 12/00
3 609 929 557 • TMS • 29.11.00
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be af-
fected. If the system impedance of the power supply is lower than 0.30 Ohm, disturbances are unlikely to occur.
1 Saw dust ejector
2 Suction adapter
3 Riving knife attachment
4 Swinging protective guard
5 Clamping flange
6 Clamping bolt with washer
7 Riving knife
8 Motor spindle
9 Mounting flange
10 Handle
(rotatable for depth-of-cut adjustment)
11 Winged screw for cutting angle setting
12 Winged screw for parallel guide
13 Base plate
14 Parallel guide
15 Switch lock
16 On/Off switch
17 Allen key
18 Cutting depth scale
19 Cutting angle scale
20 Cut mark
Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 90 dB (A); sound
power level: 103 dB (A).
Wear ear protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
The machine is intended for cutting wood length-
ways and crossways in straight lines and at mitred
angles of up to 45° on a firm surface.
Product Specification
Hand Circular Saw GKS 75 S GKS 85 S
Part number 0 601 652 0.. 0 601 653 0..
Rated input 1 600 W 1 700 W
Output power 1 000 W 1 100 W
No-load speed 4 600 RPM 4 000 RPM
Speed under load 3 100 RPM 3 000 RPM
Riving knife thickness 1.98 mm 1.98 mm
Cutting depth at 90°, max. 75 mm 85 mm
Cutting depth at 45°, max. 53 mm 60 mm
Base plate 200 x 400 mm 200 x 400 mm
Weight (without optional extras) approx. 7.3 kg 7.3 kg
Safety class / II / II
Saw blade dia. (max.) 210 mm 230 mm
Saw blade dia. (min) 200 mm 225 mm
Thickness of central blade body, max. 1.8 mm 1.8 mm
Thickness of teeth/max. crosscut 2.8 mm 2.8 mm
Thickness of teeth/min. crosscut 2.2 mm 2.2 mm
Mounting hole 30 mm 30 mm
GB
Machine Elements Noise/Vibration Information
Intended Use
GKS 75 S/85 S.book Seite 10 Donnerstag, 30. November 2000 2:47 14
To Next Page
Loading...
