Bosch GLM 100 C User Manual

-24-
– The front measuring edge of tool (e.g. when measuring onward from a
table edge),
– The centre of measurement reference thread 19 (e.g. for measurement
made on a tripod).
To select the measurement reference, press button 10 until the requested
measurement reference is indicated on the display. Each time after
switching on the measuring tool, the rear edge of the measuring tool is
preset as the measurement reference.
Subsequent changing of the measurement reference for measurements
that have already been carried out (e.g. when indicating measuring values
in the measured-value list) is not possible.
“Func” Menu
To access the Basic settings/Func menu, press and hold the Func
button 8.
Briefly press the Func button 8 to select the individual menu items.
Press the minus button 5 or the plus button 11 to select the setting within
the menu items.
To exit the “Func” menu, press the measurement button 2.
Basic Settings
Tone signals On
Off
Display illumination On
Off
Auto on/off
Digital vial On
Off
Tilt Display rotation On

Bosch GLM 100 C Specifications

General

Measurement Range	0.05 – 100 m
Accuracy	± 1.5 mm
Laser Class	2
Bluetooth	Yes
Dust and Water Protection	IP54
Laser Diode	635 nm, < 1 mW
Measurement Time, typical	0.5 s
Measurement Time, max.	4 s
Memory Capacity (Values)	50
Dimensions	111 x 51 x 30 mm
Automatic Deactivation	5 min
Weight, approx.	0.14 kg
Units of Measurement	m, in, ft
Data Transfer	Bluetooth
Storage Temperature	-20°C to +70°C