Bosch GreenTronic 7000 T - Page 15

Installation and Operating Instructions
Bosch GreenTronic 7000 T Hybrid Electric Water Heater - BTC 755003301 A (03.2024)
| 17
No. Icon Description
1
Main Display: This icon will be illuminated if the screen is unlocked. It shows the following values:
• The measured water temperature in the tank
• The setpoint temperature
• Remaining days of vacation in vacation mode
• Error code if fault is detected, see troubleshooting section for more details
2
Time and Clock Setting: This icon shows the current time. This value must be set upon installation. It also shows the time when using the scheduling
function.
3
Scheduling: This icon is used to show the scheduling programmed by the user. If no scheduling is used, the icon will not be present. For the scheduling
function:
• The day that has been scheduled will be displayed
• The dots and dashes represent different scheduled on/off cycles on a given day
• The day and time that is being scheduled will flash on and off when being set
4
Maintenance Reminder: This icon will ash to remind the user to conduct maintenance on the product. The time interval is default to 365 days and can be
set in the engineering settings.
5 Child Lock: This icon will be displayed when the child lock is activated. This will prevent all operational buttons from being pressed.
6
Hybrid Mode: This icon will be displayed when hybrid mode is selected. This mode will minimize recovery time while still utilizing the heat pump and
allows the heating element and heat pump to run simultaneously under certain operating conditions.
7
Electric Resistance Heating Element: This icon is displayed when the heating element is being used to heat the water. The electric resistance element
button can also be used to manually activate the heating elements if the operation mode and conditions allow.
8 Scald Risk Alert: This icon is displayed when the temperature is higher than 122°F (50°C) to notify the user of high water temperatures.
9 Error Alert: This icon is displayed when there is an error and/or lockout. Contact a qualied technician if activated.
10 Vacation Mode: This icon is displayed when vacation mode is selected. In this mode, the tank will maintain the temperature at 59°F (15°C) to save energy.
11
E-Heater Mode: This icon is displayed when E-Heater mode is selected. This mode will only utilize the electric resistance heating elements to heat up the
water.
12
Economy Mode: This icon is displayed when economy mode is selected. This is the default mode and will heat the water as high as possible before using
electric resistance heating elements.
13
Heat Pump Mode: This icon is displayed when heat pump mode is selected. This mode will allow only the heat pump to function unless the unit is under
certain extreme operating conditions.
14 Invalid: If a function or button is invalid, the icon will temporarily ash.
15 Set Temperature: This icon is displayed when the user is setting the water heater temperature.
16 Clock: This icon is displayed when the clock is being set.
17 Heat Pump: This icon is displayed when the heat pump is operating.
18
Demand Response (DR): This icon is displayed when the user presses the "DR" button to turn on demand response functionality. If a UCM is connected to
the unit and the water heater receives a power limit request, basic or advanced load request, or emergency curtailment request, it will ash slowly. If there
is an emergency shutdown request, the icon will ash quickly.
Table 15 Display icon descriptions