en
44
Ice maker
Fault Possible cause Remedial action
The ice maker doesn’t
work.
Ice maker is not
connected
to the mains supply.
Call customer service.
The ice maker is
switched off.
Switch on the ice maker (see “Ice
maker”).
Ice maker does not
receive any fresh
water.
Ensure that the water is properly
connected.
The freezer
compartment
temperature is too
warm.
Check freezer compartment
temperature and, if required, set
slightly colder.
The ice maker does
not make enough ice
or the ice is deformed.
The appliance or ice
maker has only just
been switched on.
Approx. 24 hours is needed until ice
production starts.
A lot of ice has been
taken.
Approx. 24 hours is needed until
the ice cube container is filled again.
Low water pressure. Connect the appliance
to the stipulated water pressure only
(see chapter “Connecting
the appliance”, section “Water
connection”).
The freezer
compartment
temperature is too
warm.
Set temperature colder.
Screen on the water
supply is dirty.
Clean the screen.
Ice dispenser does not
function.
The “lock” and “on/
off” buttons flash.
Water has escaped
from the pipe system.
The integrated
AquaStop system has
interrupted the water
supply.
Switch off the water supply
and inform customer service (see
chapter entitled Alarm function).
To Next Page
Loading...
