You have purchased a Bosch GTA500 Folding
Table Saw Stand for the GTS1031 Table Saw.
Designed for job site use, this unit sets up and
folds quickly.
Sort out and account for all parts to make sure
that you have all necessary materials to
assemble your stand. Do not discard packing
material until all parts are accounted for.
3%,
37 !13%2#1)/3).-
A (1) Stand
B (4) Stand Leg
C (4) Bolt
D (4) Lock Nut
1%22%,"+7
!&%37-2314#3).-2
%!$ !-$4-$%123!-$ !++
)-2314#3).-2Failure to follow
all instructions listed below may result in
serious personal injury.
4++7!22%,"+%!-$3)'(3%-!++3(%&!23%-%12
1%04)1%$&.13()223!-$+2.1%,%,"%13.
.##!2).-!++7 #(%#* 3(% 23!-$!-$ ,!*%
241%)3)223)++3)'(3A loose stand is unstable
and may shift in use and cause serious injury.
41-3..+26)3#(.&&!-$$)2#.--%#3/.6%1
"%&.1% ,.4-3)-' 3. 3(% 23!-$ Unintended
startup during assembly can cause injury.
%&.1%./%1!3)-',!*%241%3(%%-3)1%4-)3
)2/+!#%$ .- ! 2.+)$ &+!3 +%5%+ 241&!#%
Serious injury could occur if tool is unstable
and tips.
%5%123!-$.-3..+.1)3223!-$.142%!2
+!$$%1 .1 2#!&&.+$)-' Serious injury could
occur if the tool is tipped or the cutting tool is
accidentally contacted. Do not store materials
on or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
2% .-+7 .2#( 1%/+!#%,%-3 /!132 Any
others may create a hazard.
!
WARNING
-2-
22%,"+)-'3(%3!-$
1. Slide the legs into the stand (Fig. 1).
.3% Each leg is marked A, B, C, or D.
These correspond with the respective leg
on the main stand. Match A with A and B
with B, etc.
2. Align the hole in the leg with the hole in the
stand.
3. Install a bolt through each leg.
4. Use a wrench and a phillips screwdriver
and tighten the nuts securely.
22%,"+7
FIG. 1
To Next Page
Loading...
