EasyManua.ls Logo

Bosch GWH 425 HN User Manual

Bosch GWH 425 HN
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Water heaters for use with Natural and L.P.G.
GWH 425 HN
Flow Modulated with Electronic Ignition
Suitable for heating potable water only - Not approved for space heating purposes
(Intended for variable flow applications with steady cold water inlet temperatures)
GWH-425-HN-N
GWH-425-HN-L
6 720 607 026 US (04.11) AL
Warning: If the information in this manual is not
followed exactly, a fire or explosion may result
causing property damage, personal injury or death.
Do not store or use gasoline or other flammable
vapor and liquids in the vicinity of this or any other
appliance.
Improper installation, adjustment, alteration,
service or maintenance can cause injury or
property damage. Refer to this manual. For
assistance or additional information consult a
qualified installer, service agency or the gas
supplier.
In the Commonwealth of Massachusetts this
product must be installed by a licensed plumber or
gas fitter.
Upon completion of the installation, these
instructions should be handed to the user of the
appliance for future reference.
What to do if you smell gas
Close gas valve. Open windows.
Do not try to light any appliance
Do not touch any electrical switch; do not use any
phone in your building
If you cannot reach your gas supplier, call the fire
department.
Immediately call your gas supplier from a neighbors
phone. Follow the gas supplier’s instructions.
Installation and service must be performed by a
qualified installer, service agency or the gas supplier.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Bosch GWH 425 HN and is the answer not in the manual?

Bosch GWH 425 HN Specifications

General IconGeneral
BrandBosch
ModelGWH 425 HN
CategoryWater Heater
LanguageEnglish

Summary

Safety Information

General Warnings

Crucial safety advice regarding installation, fire, and explosion risks.

Smelling Gas Procedures

Step-by-step actions if gas odor is detected.

General Safety and Operational Guidelines

Installation and Maintenance Warnings

Cautions against improper installation, adjustment, and service.

Principle of Operation

Product Features

Unpacking the Water Heater

Installation Clearances

Clearance Requirements

Specifies minimum distances to combustible materials.

Safe Operation Rules

Heater Location Requirements

Combustion Air and Ventilation

Importance of adequate air supply and proper venting for safe operation.

Combustion Air Requirements

Mounting Installation

Venting Requirements

Gas Vent Termination Guidelines

Specifies height and location for vent termination.

Masonry Chimney Venting

Exterior Masonry Chimney Venting

Guidance for venting into exterior masonry chimneys.

Checking Draft Performance

Procedure to test for proper venting and safety.

Gas Connections

Gas Pressure Settings

Specifies required inlet gas pressure for different altitudes.

Gas Line Sizing Guide

Tables for determining correct pipe size based on BTU and length.

Gas Piping and Sizing

Gas Line Sizing Charts

Tables for sizing natural gas and LP gas lines.

Water Connections

Pressure Relief Valve Installation

Instructions for installing the PRV and discharge line.

Operating Instructions

Pre-Operation Safety Checks

Essential safety steps before turning the unit on.

Lighting and Operation

Turning Off the Appliance

Procedure for safely shutting down the water heater.

Adjusting Water Temperature

How to set the desired hot water temperature.

Maintenance and Service

Maintenance Schedule & Procedures

Covers annual checks, vent, water valve, pilot, burners, scale.

Trouble Shooting Guide

Troubleshooting: Ignition Failures

No Spark at Pilot

Common causes and solutions for lack of pilot spark.

Pilot Ignites, Burners Fail

Reasons why burners won't light after pilot ignition.

Troubleshooting: Operational Issues

Ignition and Burner Problems

Diagnosing pilot, burner ignition, and shut-off issues.

Water Temperature Problems

Troubleshooting issues with water being too hot or too cold.

Troubleshooting: Temperature Fluctuations

Temperature Fluctuations / Unit Deactivation

Addressing issues with unstable or interrupted hot water.

Operational Flowchart

Pre-start Procedure

Steps taken before the unit begins operation.

Ignition Procedure

Sequence of events for lighting pilot and main burners.

Safety Monitoring

Continuous safety checks during operation.

Limited Warranty Information

Warranty Coverage Details

Explains coverage for heat exchanger and other parts.

Warranty Exclusions

Lists conditions under which warranty is void.

Service Labor and Claims

Covers labor costs and how to make a warranty claim.

Related product manuals