9001080874 Rev A English 7
Adjust Broil Burner Orifice
1. Remove oven door (See section “Removing Oven
Door” in Use and Care Manual).
2. Remove Broil Burner Assembly. The broil burner
assembly is attached to the top of the oven cavity with
five (5) screws. Remove screws and gently pull broil
burner assembly straight out being careful not to
detach electrical wires. Place broil burner against back
wall of oven cavity.
3. Use 1/2 inch (13 mm) wrench to remove the natural
gas orifice and install the separate LP gas orifice
provided. The orifice is located inside the oven cavity at
the top right (visible with burner assembly removed.)
4. Use a Phillips head screwdriver to loosen the screw in
broil burner air shutter. Once loosened, take the LP
conversion jig and place the THINNEST cylinder into
the air shutter. Turn air shutter until it fits tightly against
the pin. Tighten the Phillips screw in the air shutter and
remove the LP conversion jig. DO NOT LEAVE LP
CONVERSION JIG IN AIR SHUTTER!
Note: The air shutter on the broil burner fits over the orifice
when installed correctly.
Adjust Bake Burner Orifice
The bake burner orifice is located below the air shutter
(See Figure 3). Reach it through the access hole in the
interior back panel of the warming drawer cavity.
1. Use a 1/2” wrench to turn orifice clockwise until it stops
(2 1/2 - 3 turns). Unlike the broil burner orifice, the bake
burner orifice should be tightened as far as it will go in
order to ensure that complete conversion has
occurred.
2. Use a Phillips head screwdriver to loosen the screw in
the bake burner air shutter. Once loosened, turn the air
shutter to its widest position (see figure below). Tighten
the Phillips head screw in the air shutter.
Figure 3: Bake Burner Orifice Adjustment
To Next Page
Loading...
