Step 4: installing The Microwave Oven (continued)
Step B
1, Remove the one existing screw from the Heftside of the microwave oven,
2, Connect the side duct to upper duct as shown,
a) hsert projecting tabs of upper duct into holies of side duct,
b) Bend tabs up as shown,
NOTE: Remove any oi[ or dirt on surface of microwave oven before ducts are attached,
a) Upper Duct b)
3 ta bs_
! 3 holies
I
Side Duct
,
Pee[ off the backing of douMe-sided tape, Attach
the side duct and upper duct assemMy on the mi-
crowave cabinet, Press down firmHy on ducts, Fas-
ten duct assemMy to Heft side of cabinet with one
existing screw,
Step C
1, On the cutout floor, mark hole centers for the
anti-tip brackets as shown using the supplied
template, Be sure to align the center line of tem-
plate to center line of cutout floor,
2, Drill two holes for anti-tip bracket, (Use 7/64" drill
or #35 drill)
3, hstaH anti-tip bracket onto cutout floor using two
1/2" screws,
DIMENSIONS:
A = 4-1/4 ''
B=3"
C = 18-3/16 ''
I Centerline
Cutout Floor
IF
71J2,,Screwst2/I
I
I I
nti-tip Bracket
t _
To Next Page
Loading...
