Step 4: installing the Microwave Oven (continued}
Step D
1. Slide microwave oven part way into cabinet
opening. (Bottom bracket must be flat to the
cutout floor to engage correctly with anti-tip
brackets as shown).
2, Plug in the microwave oven,
3, Center the microwave oven within the cutout
opening and siide the microwave oven in the
anti-tip bracket, (Ensure the microwave oven is
accurateiy centered,
4, Drill[ piiot hobs (use 7/64" drill[ or #35 drii[)
through the positioning flange and then install[
three 1/2" screws at the front of the bottom duct
as shown.
Step 5: installing the Trim Kit
Bracket
Bottom
Bracket
,("Z ,_.'"
1/2" screws
flange
Cutout
opening
1. Place the trim kit frame over the microwave oven,
,
,
4,
,
,
important Note: Trim kit frame orientation is
important, Orient the frame
so the louvers are sloping
downward to the front, (gee
Figure Detail A).
Make sure the trim kit is level and centered with
respect to microwave oven, Mark four hob cen-
ters through the four mounting hobs of the trim
kit,
NOTE: Center the trim kit frame equally on aii
four sides,
Remove the trim kit and drill four pilot hobs, (use
7/64 drill or #35 drill)
Attach the trim kit frame by using four 1" screws,
Make sure that the orientation is correct as
stated above,
Your trim kit is now fully installed° Replace
an}i loose items that have been removed from
inside microwave oven,
Please keep this installation instruction for future
reference,
WWA_W
" Screw[
i
I
' o
Pilot
hob
J
Trim Kit
Cutout
Opening
hob
Figure Detail of "A"
To Next Page
Loading...
