EasyManua.ls Logo

Bosch HMT72M450B - Causes of Damage; Installation and Connection

Bosch HMT72M450B
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
the liquid reaches boiling temperature
without the usual steam bubbles rising to
the surface. Even if the container only
vibrates a little, the hot liquid may
suddenly boil over and spatter. When
heating, always place a spoon in the
container. This will prevent delayed
boiling.
Risk of injury!
Scratched glass in the appliance door
may develop into a crack. Do not use a
glass scraper, or sharp or abrasive
cleaning aids or detergents.
Ris k of injury!
Unsuitable ovenware may crack. Porcelain
or ceramic ovenware can have small
perforations in the handles or lids. These
perforations conceal a cavity below. Any
moisture that penetrates this cavity could
cause the ovenware to crack. Only use
microwave-safe ovenware.
Causes of damage
Caution!
Heavily soiled seal: If the seal is very dirty, the appliance door
will no longer close properly during operation. The fronts of
adjacent units could be damaged. Always keep the seal
clean.
Operating the microwave without food: Operating the
appliance without food in the cooking compartment may lead
to overloading. Never switch on the appliance unless there is
food in the cooking compartment. An exception to this rule is
a short crockery test (see the section "Microwave, suitable
crockery").
Microwave popcorn: Never set the microwave power too
high. Use a power setting no higher than 600 watts. Always
place the popcorn bag on a glass plate. The disc may jump if
overloaded.
Liquid that has boiled over must not be allowed to run
through the turntable drive into the interior of the appliance.
Monitor the cooking process. Choose a shorter cooking time
initially, and increase the cooking time as required.
Never use the microwave oven without the turntable.
Installation and connection
This appliance is intended for domestic use only.
Place the tabletop appliance on a firm, level surface (at least
85 cm above the floor). The ventilation slots at the rear, top and
bottom of the appliance must not be obstructed. The minimum
height of the free space above the surface of the appliance is
30 cm.
The appliance is fitted with a plug and must only be connected
to a properly-installed earthed socket. The fuse protection must
be rated at 10 amperes (L or B circuit breakers). The mains
voltage must correspond to the voltage specified on the rating
plate.
The socket must be installed and the power cable replaced by
a qualified electrician only. The appliance plug must always be
accessible.
Do not use multiple plugs, power strips or extension leads.
Overloading results in a risk of fire.
Note: You can fasten your microwave appliance directly to the
underside of a wall cupboard in the kitchen. Refer to the
special mounting template.




Related product manuals