-34-
Read all instructions.
Failure to follow all
instructions listed below may result in
hazardous radiation exposure, electric
shock, fire and/or serious injury.
t )BWF UIFSFNPUF DPOUSPM SFQBJSFEPOMZ
through a qualified repair person and
only using identical replacement parts.
This will ensure that the functionality of
the remote control is maintained.
t %P OPUPQFSBUF UIF SFNPUFDPOUSPM JO
explosive atmospheres, such as in the
presence of flammable liquids, gases
or dusts. Sparks can be created in the
remote control which may ignite the dust
or fumes.
t 3FBE BOETUSJDUMZ PCTFSWF UIFTBGFUZ
warnings in the operating instructions
of the rotational laser.
RC1 General Safety Rules
RC1 Intended Use
The remote control is intended for controlling rotational laser levels in indoor and outdoor use.
RC1 Preparation
Inserting/Replacing the Battery
Using alkali-manganese batteries is recom-
mended for operation of the remote control.
To open the battery lid 8c, press the latch 9c
in the direction of the arrow and remove the
battery lid. Insert the battery provided.
When inserting, pay attention to the correct
polarity according to the representation on
the inside of the battery compartment.
Remove the battery
from the remote control
when not using it for longer periods.
When storing for longer periods, the battery
can corrode and self-discharge.
RC1 Technical Data
1) The working range can be decreased by unfavorable environmental conditions (e.g. direct sun
irradiation).
Please observe the article number on the type plate of your remote control.
The trade names of individual remote controls may vary.
For clear identification of your remote control, see the serial number 10c on the type plate.
Remote control RC1
Working range
1)
100 ft (30 m)
Operating temperature
14 °F ~ 122 °F (–10 °C ~ +50 °C)
Storage temperature
Battery
1 x 1.5 V LR06 (AA)
Weight according to
EPTA-Procedure 01/2003
2.4 oz. (69 g)
–4 °F ~ 158 °F (–20 °C ~ +70 °C)
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
