Troubleshooting en
51
Fault Cause and troubleshooting
E:61-03 will light up
alternately. Water is
not drained.
Not an appliance fault. Siphon connection is still
closed or the wastewater hose is kinked or blocked.
1. Check the connection to the siphon and open if ne-
cessary.
2. Install wastewater hose without kinks.
3. Remove residues.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
1. Clean the wastewater pump.
→"Clean wastewater pump", Page55
2. Secure the cover of the wastewater pump so it
clicks into position.
→"Clean wastewater pump", Page55
E:92-40 will light up
alternately.
Filters are soiled or blocked.
▶ Clean the filters.
→"Cleaning filters", Page47
All LEDs lit up or
flashing.
A software update is possibly installing.
1. Wait until the software update has been installed.
This process can take approx. 30minutes.
2. If the appliance is not ready to use after
30minutes, perform a reset.
‒ Press the main switch button for approx.
4seconds.
a Your appliance is resetting.
To Next Page
Loading...
Need help?
General
