Getting to know your appliance en
5
*Getting to know your
appliance
Get t i ng to know your appl i ance
You can find the hob dimensions in the overview of
models. ~ Page 2
The control panel
The hotplates
Notes
■ Any dark areas in the glow pattern of the hotplate
are due to technical reasons. The function of the
hotplate is not affected.
■ Hotplate temperature is regulated by the heat
switching on and off.The heat may also switch on
and off at the highest setting.
This ensures e.g.:
– sensitive components are protected from
overheating
– the appliance is protected from electrical
overload
– better cooking results are achieved
■ With multi-circuit hotplates the heater elements of the
inner filament circuits and the heater element of the
activations may switch on and off at different times.
Hotplate and residual heat indicator
The hotplate and residual heat indicator lights up when
a hotplate is warm:
■ Hotplate indicator - during operation, shortly after
you have switched on a hotplate.
■ Residual heat indicator - after cooking, when the
hotplate is still warm.
You can use the residual heat to save energy, e.g. to
keep a small meal warm or to melt chocolate.
Symbols
e
Hotplate and residual heat indicators
Î
Front hotplate
Ï
Rear hotplate
Hotplate Activating and deactivating
$
Single-circuit hotplate
ð
Dual-circuit hotplate Activation: turn hotplate switch to the
right as far as ð. Set the heat setting.
Switching off: turn the hotplate switch to
0 and make new setting. Never turn the
hotplate switch past the symbol ð to 0.
To Next Page
Loading...
