36 | English
2 609 141 217 | (7.11.14) Bosch Power Tools
Area Measurement
Use area measurement to measure the length and width one after the other as with a
length measurement. The laser beam remains switched on between the two measure-
ments. After the second measurement has been completed, the area will be automat-
ically calculated and displayed.
Press the k button and then select the button for area measurement .
Volume Measurement
Use volume measurement to measure the length, width and height one after the other
as with a length measurement. The laser beam remains switched on between the
three measurements. After the third measurement has been completed, the volume
will be automatically calculated and displayed.
Press the k button and then select the button for volume measurement .
Addition/Subtraction of Lengths
Use addition/subtraction of lengths to measure lengths (distances, clearances, etc.)
and to add or subtract the individual values (e.g. helpful when calculating materials).
Press the k button and then select the button for length calculation .
To complete the addition/subtraction, press the measuring button 1. Select the
button to add/subtract further values.
Addition/Subtraction of Areas
Use addition/subtraction of areas to measure areas and to add or subtract the individ-
ual areas (e.g. helpful when calculating materials).
Press the k button and then select the button for area calculation .
To complete the addition/subtraction, press the measuring button 1. Select the
button to add/subtract further values.
Addition/Subtraction of Volumes
Use addition/subtraction of volumes to measure volumes and to add or subtract the
individual volumes (e.g. helpful when calculating materials).
Press the k button and then select the button for volume calculation .
To complete the addition/subtraction, press the measuring button 1. Select the
button to add/subtract further values.
Values above 999999 m
3
or below –999999 m
3
cannot be shown; “ERROR” ap-
pears on the display.
OBJ_BUCH-2326-002.book Page 36 Friday, November 7, 2014 10:15 AM
To Next Page
Loading...
