40 | English
2 609 141 217 | (7.11.14) Bosch Power Tools
The connection between mobile terminal/device and measuring tool is established af-
ter the Bosch application has started. If multiple active measuring tools are found, se-
lect the appropriate measuring tool.
The connection status and the active connection are displayed in the status bar of the
measuring tool (a).
If no connection can be established within 5 minutes of pressing the Bluetooth® j but-
ton, Bluetooth® will automatically switch off to save the batteries/rechargeable bat-
teries.
Deactivating the Bluetooth® Interface
To deactivate the Bluetooth® interface, press the Bluetooth® j button or switch the
measuring tool off. Alternatively, the Bluetooth® interface can be deactivated via the
“Basic Settings” menu (see page 35).
Working Advice
The measuring tool is equipped with a radio interface. Local operating restric-
tions, e.g. in airplanes or hospitals, are to be observed.
General Information
The reception lens 9 and the laser beam outlet 8 must not be covered when taking a
measurement.
The measuring tool must not be moved while taking a measurement (with the excep-
tion of the continuous measurement and grade measurement functions). Therefore,
place the measuring tool, as far as this is possible, against or on a firm stop or support-
ing surface.
OBJ_BUCH-2326-002.book Page 40 Friday, November 7, 2014 10:15 AM
To Next Page
Loading...
