English – 10
The five LEDs on the battery charge indicator(2) indi-
cate the battery's state of charge when the eBike bat-
tery is switched on.
Each LED represents approximately 20% of the
charging capacity. When the eBike battery is fully
charged, all five LEDs will be lit.
The eBike battery's state of charge when switched on
is also shown on the display of the on-board com-
puter. Read and follow the instructions in the operat-
ing manuals for the drive unit and on-board com-
puter.
If the eBike battery's capacity is less than 10%, the
last remaining LED will flash.
Once charging is complete, disconnect the eBike bat-
tery from the charger and the charger from the mains.
Laying the Cable on the PowerMore
Battery Holder
Note: When laying the cable(6), make sure that the
cable(6) is fed under the release button(10). This
prevents the release button(10) from being pressed
accidentally and causing the PowerMore battery to be
released.
Inserting and Removing the PowerMore
Battery
u When inserting the battery into the holder or re-
moving it from the holder, always switch off the
eBike battery and the eBike beforehand.
u Once you have inserted the eBike battery, check
that it is correctly positioned and secure in all
directions.
u Only leave the PowerMore battery with the ca-
ble connected to the eBike.
u Once the PowerMore battery is installed, the
connection socket of the battery must not face
upwards.
Inserting the PowerMore Battery
(1)(10) (11)
(11)
(3) (4)
(7)
(8)
(6)
To insert the battery(1), place its guide
grooves(12) onto the guide rails(11). Ensure that
the battery is aligned correctly and that the battery is
0 275 U07 3RE | (20.03.2023) Bosch eBike Systems
To Next Page
Loading...
