English | 5
Bosch Power Tools 3 609 929 D01 | (7.3.14)
Safety Warnings for Impact Wrenches
Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may con-
tact hidden wiring or its own cord. Fasteners contacting
a “live” wire may make exposed metal parts of the power
tool “live” and could give the operator an electric shock.
Never use the machine with a damaged cable. Do not
touch the damaged cable and pull the mains plug when
the cable is damaged while working. Damaged cables in-
crease the risk of an electric shock.
Use auxiliary handle(s), if supplied with the tool. Loss
of control can cause personal injury.
Hold the machine with a firm grip. High reaction torque
can briefly occur while driving in and loosening screws.
When working with the machine, always hold it firmly
with both hands and provide for a secure stance. The
power tool is guided more secure with both hands.
Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
WARNING! Important instructions for connecting a new
3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to the following
code:
Do not connect the blue or brown wire to the earth terminal of
the plug.
Important: If for any reason the moulded plug is removed
from the cable of this power tool, it must be disposed of
safely.
Products sold in AUS an NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
Intended Use
The machine is intended for driving in and loosening screws
and bolts as well as for tightening and loosening nuts within
the respective range of dimension.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Suspension hook
2 Auxiliary handle
3 Threaded for auxiliary handle
5 On/Off switch
5 Rotational direction switch
6 Tool holder
7 Tool bit
8 Handle (insulated gripping surface)
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.
Technical Data
Impact Wrench GDS 24 GDS 30
Article number
0 601 434 1.. 0 601 435 1..
Rated power input
W800920
Output power
W400500
No-load speed
min
-1
1260 1260
Max. torque for hard/soft screwdriving application according to
ISO 5393
Nm 600/300 1000/500
Right/left rotation
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
OBJ_BUCH-550-002.book Page 5 Friday, March 7, 2014 1:03 PM
To Next Page
Loading...
