English | 9
Bosch Power Tools 1 609 92A 3FM | (21.2.17)
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The machine is intended for cutting, roughing and brushing of
metal and stone materials without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 On/Off switch
3 Thumbwheel for speed preselection (GWS 9-115 S/
GWS 9-125 S)
4 Auxiliary handle (insulated gripping surface)
5 Combination spanner for M 14 grinder spindle*
6 Grinder spindle
7 Protection guard for grinding
8 Locking screw for protection guard
9 Mounting flange with O-ring
10 Grinding wheel*
11 Clamping nut
12 Quick-clamping nut *
13 Carbide grinding head*
14 Protection guard for cutting*
15 Cutting disc*
16 Hand guard*
17 Rubber sanding plate*
18 Sanding sheet*
19 Round nut*
20 Cup brush*
21 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Angle Grinder GWS... 9-115 9-125 9-115 S 9-125 S
Article number
3 601 ... C96 0.. C96 0.. C96 1.. C96 1..
Rated power input
W 900 900 900 900
Output power
W 450 450 450 450
Rated speed
min
-1
11000 11000 11000 11000
Speed control adjustment
min
-1
– –2800
–11000
2800
–11000
Grinding disc diameter, max.
mm 115 125 115 125
Thread of grinder spindle
M 14 M 14 M 14 M 14
Thread length (max.) of grinder spindle
mm 22 22 22 22
Speed preselection
– –
Restarting Protection
– –
Weight according to EPTA-Procedure
01:2014
– with vibration-damping auxiliary handle
– with standard-auxiliary handle
kg
kg
2.0
1.9
2.0
1.9
2.0
1.9
2.0
1.9
Protection class
/II /II /II /II
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
OBJ_BUCH-3141-001.book Page 9 Tuesday, February 21, 2017 3:24 PM
To Next Page
Loading...
