2 609 001 148 • 14.12.06
English | 27
09.11.2006, Robert Bosch GmbH, Power Tools Division
D-70145 Leinfelden-Echterdingen
Assembly
Battery Charging (see figure A)
f Do not use other battery chargers. The supplied battery
charger is designed for the Lithium-Ion battery in your machine.
The Li-ion battery is protected against deep discharging by the
“Electronic Cell Protection (ECP)”. When the battery is empty, the
machine is switched off by means of a protective circuit: The
inserted tool no longer rotates.
Do not continue to press the On/Off
switch after the machine has been auto-
matically switched off. The battery can be damaged.
When the battery charge-control indicator 4 lights up red while
the On/Off switch 8 is depressed half way, then the battery has
less than 30% of its capacity and should be charged.
The charging procedure starts as soon as the main plug of the bat-
tery charger is inserted into the socket and the cordless screw-
driver is afterwards placed on the battery charger 11.
The battery charge-control indicator 4 indicates the charging
progress. The indicator lights up green during the charging proc-
ess. When the battery charge-control indicator 4 is no longer lit,
the battery is fully charged.
During the charging procedure, the handle of the machine warms
up. This is normal.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
WARNING
OBJ_BUCH-88-003.book Page 27 Thursday, December 14, 2006 10:30 AM
To Next Page
Loading...
