2 609 001 148 • 14.12.06
English | 29
Position 1:
Lower torque for screwing in screws with small diameter or into
soft materials.
Position 6:
Higher torque for screwing in screws with large diameter or into
hard materials.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it
depressed.
The power light 10 lights up when the On/Off switch 8 is slightly
depressed, and enables illumination of the screwing location in
unfavourable light conditions.
To switch off the machine, release the On/Off switch 8.
Fully automatic spindle locking (Auto-lock)
The drill spindle is locked when the On/Off switch 8 is not
pressed.
This enables screws to be screwed in, even when the battery is
empty and allows for the machine to be used as a screwdriver.
f When the drilling spindle is locked, do not press the
On/Off switch 8 for more than 15 seconds. Otherwise
the power tool can be damaged.
Operating Instructions
f Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Soft Grip
The gripping surface (soft grip) 7 reduces the danger of slipping
and thereby improves the grip on the machine and the handling.
At the same time, the rubber coating achieves a vibration-reducing
effect.
OBJ_BUCH-88-003.book Page 29 Thursday, December 14, 2006 10:30 AM
To Next Page
Loading...
