English | 17
Bosch Power Tools 2 609 004 199 | (27.1.10)
Sanding sheets without holes, e. g. from rolls or
by the meter, can be punctured with the perfo-
rating tool 11 for use with dust extraction. For
this, press the machine with the mounted sand-
ing sheet onto the perforating tool
(see figure E).
To remove the sanding sheet 6, unlatch the
sanding-sheet clamp 4 and pull out the sanding
sheet.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
Dust/Chip Extraction
f Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one’s health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Integrated Dust Extraction with Dust Box
(see figures C1–C4)
Attach the dust box 3 onto the extraction outlet
8 until it latches.
To empty the dust box 3, pull off the dust box
downward.
Before opening the dust box 3, it is recommend-
ed to loosen the dust from the filter element by
gently striking it against a firm support (as
shown in the figure).
Grasp the dust box 3 by the recessed grip, fold
the filter element 9 upward and empty the dust
box. Clean the thin plates of the filter element 9
with a soft brush.
External Dust Extraction (see figure D)
Insert a vacuum hose 10 onto the extraction out-
let 8. Connect the vacuum hose 10 to a vacuum
cleaner. See the overview for connecting to var-
ious vacuum cleaners at the end of these oper-
ating instructions.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Grain size
For the working of all
wooden materials
40—240
For coarse-sanding,
e. g. of rough, un-
planed beams and
boards coarse 40, 60
For face sanding and
planing small irregu-
larities
medi-
um 80, 100, 120
For finish and fine
sanding of hard
woods fine 180, 240
For the working of
paint/enamel coats
or primers and fillers
40—320
For sanding off paint coarse 40, 60
For sanding primer medi-
um 80, 100, 120
For final sanding of
primers before coat-
ing fine 180, 240, 320
OBJ_BUCH-60-003.book Page 17 Wednesday, January 27, 2010 2:49 PM
To Next Page
Loading...
