Bosch Rexroth NX-BP2-36V

Questions and Answers

T
Tracy RosalesAug 9, 2025
Why is my Bosch Rexroth NX-BP2-36V Battery Pack not holding a charge?
- L
  Lisa NashAug 9, 2025
  There are several reasons why your Bosch Battery Pack may not be holding a charge. It could be that the battery is not fully charged, so ensure you fully charge it. If an increased torque was used for tightening, the number of tightening operations is automatically reduced. The number of charging cycles for the battery may have been exceeded, in which case you should replace the battery.
M
Matthew ClayAug 14, 2025
What to do if my Bosch Rexroth NX-BP2-36V charger indicates a battery fault?
- S
  stoneyvonneAug 14, 2025
  If the charger indicates a battery fault, it could mean the battery is defective, requiring disposal and replacement according to regulations. It could also be a temporary fault, in which case you should wait for 10 minutes and retry.
N
nancy51Aug 19, 2025
What does it mean when LED1 flashes on my Bosch Battery Pack at 5Hz?
- G
  Gloria ButlerAug 19, 2025
  A flashing LED1 at 5Hz with a 50% duty cycle can indicate several issues during charging. It could mean there's overtemperature, cell overvoltage, or overcurrent. It might also indicate that the charging timer (capacity limitation) has been exceeded. Remove the battery and check the battery charger using different batteries to troubleshoot.
C
Crystal BrownAug 25, 2025
How to fix Bosch Rexroth NX-BP2-36V when LEDs 1, 3, and 5 are flashing?
- E
  Elizabeth BondAug 25, 2025
  If LEDs 1, 3, and 5 are flashing at 5Hz, it indicates that the BMS name plate and the stored CheckSum (CRC) do not comply with the battery charger’s calculation, which may, however, be caused by disturbed communication. Remove the battery and check the battery charger using different batteries. Separate the battery charger from the mains, plug it in again and repeat the check.
E
Erin MorganAug 29, 2025
What does it mean when all LEDs are flashing on my Bosch Battery Pack charger?
- J
  Jeanne RichardsAug 29, 2025
  If LEDs 1, 2, 3, 4, and 5 are flashing at 5Hz, it means that the temperature at the internal heat sink is less than 0° C or greater than 100°, or the fan does not reach the required speed. Separate the battery charger from the mains, plug it in again, and repeat the check.
J
Jeremy SimpsonSep 3, 2025
Why is my Bosch Battery Pack charger not showing any indication?
- J
  Jim NobleSep 3, 2025
  If the charger indicates nothing, check the power supply to ensure the cable is properly inserted.