NLBasic settings
Basic setting
Water connection
Choice Description
Cold water1
hot water
Set cold water connection or hot water
connection.
Only set the device to Hot water if the hot water is
prepared in an energy-efficient manner and if a
suitable installation is available, e.g. a solar
cylinder with a circulation line. The water
temperature must be a minimum of 40 °C and a
maximum of 60 °C.
Eco forecast On
Out1
Turn Eco Forecast on or off.
During program selection, the average water
and energy consumption is briefly shown in
the display.
EmotionLight Out
on via
main switch1
On when opening
door
Switch the interior lighting of the device
on or off.
The interior lighting switches off automatically
after 10 minutes when the door is open.
time light On1
Out
Enable or disable "Timelight". During the program
run, status information such as the time
remaining is projected on the floor below the
appliance door. The indication is not visible with a
pre-inserted plinth plate or with a high installation
with a flush-fitting furniture front.
Launcher Eco 50°C1
Last selected program
Set the default program when the
device is switched on.
"Programs", Page 20
Signal strength Scale with multiple
positions.
Set the signal volume at the end of
the program.
At position 0 the sound signals are switched off.
Key Volume
WiFi
Scale with multiple
positions
Set the key volume during operation. At
position 0 the key signals are switched off.
On
Out
Enable or disable wireless network
connection.
The basic setting "Wi-Fi" is only available after
you have connected the appliance with the
Home Connect app.
"Home Connect", page 41
1
Factory setting (may differ depending on the device type)
40
To Next Page
