Why is my Bosch Ranges oven smoking excessively during broiling?
If your Bosch Ranges oven smokes excessively during broiling, ensure you are following the broiling instructions in the Setting Oven Controls section.
How to fix Bosch Ranges surface burners that do not ignite?
If the surface burners on your Bosch Ranges do not ignite: * Ensure the surface control knob is completely turned to LITE. Push in and turn the surface control knob to LITE until the burner ignites, then turn the knob to the desired flame size. * Check for clogged burner ports. With the burner OFF, use a small-gauge wire or needle to clean the burner head slots and ignition ports. * For electric ignition models, make sure the range power cord is securely plugged into the power outlet. * In case of an electrical power outage (electric ignition models only), burners can be lit manually.
Why is my Bosch Ranges clock and timer not working properly?
If the clock and timer on your Bosch Ranges are not working properly, make sure there is electrical power to the oven.
Why is my Bosch Ranges oven light not working properly?
If the oven light in your Bosch Ranges is not working properly, replace or reinsert the light bulb if it is loose or defective.
How to fix a Bosch Ranges appliance that is not level?
If your Bosch Ranges appliance is not level, it may be due to poor installation. Ensure the floor is level, strong, and stable enough to support the range. Place an oven rack in the center of the oven, put a level on the rack, and adjust the leveling legs at the base of the appliance until the rack is level. Also, confirm that the cabinets are square and have sufficient room for appliance clearance.
Why is my Bosch Ranges entire appliance not operating?
If your entire Bosch Ranges appliance isn't operating: * Ensure the time of day is set, as the oven won't operate until this is done. * Check if there was an electrical power outage. If these steps don't resolve the issue, further assistance is needed.
What does it mean when my Bosch Ranges oven control panel beeps and displays an F code error?
If your Bosch Ranges oven control panel beeps and displays an F code error (like F10, F11, F13, F14, F15, F30, F31, or F90), it means the oven control has detected a fault or error. Press CANCEL to clear the display and stop the beeping. Then, try the bake or broil feature again.
What to do if my Bosch Ranges oven door is locked?
If your Bosch Ranges oven door is locked and won't open, even after cooling, turn the oven off at the circuit breaker and wait five minutes. Then, turn the breaker back on. This should reset the oven and make it operable again.
General| Brand | Bosch |
|---|---|
| Model | SGE53C52UC |
| Type | Built-In |
| Series | 500 Series |
| Capacity | 16 Place Settings |
| Energy Star Rated | Yes |
| Noise Level | 44 dBA |
| Wash Cycles | 6 |
| Drying System | condensation drying |
| Rack Material | Nylon |
| ADA Compliant | Yes |
| Color | Stainless Steel |
| Delay Start | Yes |
| Soil Sensor | Yes |
| Third Rack | Yes |
| Water Softener | No |
| Interior Light | No |
| Stainless Steel Tub | Yes |
| Height | 33.875 inches |
| Depth | 23.75 inches |
| Width | 24 in |
To Next Page
