Bosch SGE63E15UC - Operating the Dishwasher Controls; Starting, Cancelling, and Interrupting Cycles; Rinse Aid, Delay Start, and Signals

14
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may
increase slightly.
To turn intensive drying on:
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “d:00”.
5 Press the “C” button to turn intensive drying on or off. “d:01” = ON and “d:00” = OFF
6 Press [Start] to save setting and close the door.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display indicates “P:01”.
5 Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6 Press [Start] to save the setting.
To change the language:
1 Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display indicates “L:01”.
5 Press the “C” button until the display corresponds with your requirements.
L:02 = English
L:03 = French
L:07 = Spanish
6 Press [Start] to save the setting.