Bosch SGS2ITW33E - Basic Settings; Overview of Basic Settings; Changing Basic Settings

en Basic settings
32
Basic settings
Basic settings
Basic settings
You can configure the basic settings for your appliance to meet your needs.
Overview of basic settings
The basic settings depend on the features of your appliance.
Basic setting Display text Selection Description
Water hardness H04
1
H00 - H07 Set the water softening system to
your water hardness.
→"Setting the water softening sys-
tem", Page22
Level H00 switches the water soften-
ing system off.
Rinse aid dispensing r05 
1
r00 - r06 Set the amount of rinse aid to be dis-
pensed.
→"Setting the amount of rinse aid",
Page25
Switch the rinse aid system off with
level r00.
Intensive drying d00
1
d00 - d01 The temperature is increased during
the final rinse, which improves the
drying result. This may increase the
run time slightly.
Note:Not suitable for delicate items
of tableware.
Switch Extra Dry on "d01" or off
"d00".
Factory setting rE Start with
YES
Confirm with
Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
1
Factory setting (may vary according to model)
Changing basic settings
1. Press ⁠.
2. To open the basic settings, press
for 3 seconds.
a The display shows Hxx.
a The display shows ⁠.
3. Press repeatedly until
the display shows the required set-
ting.
4. Press repeatedly until the dis-
play shows the right value.
You can change several settings.
5. To save the settings, press
for 3 seconds.