InfoLight ®
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 15) and press [Start] until the display indicates "H:0x".
(x can be any number)
3 Release both buttons.
4 Press the "A" button until the display shows "1:01".
5 Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
Aquastop ® Leak Protection
Our AquaStop ® system contains leaks through a precisely engineered tub and sensor system that works
with our solid molded base. If a leak has occurred, it shuts down operation and automatically pumps
out water to avoid contact with the floor. It works 24/7 and can turn itself on.
17
To Next Page
Loading...
