Dishwasher Setup
Water Softening System
Your dishwasher requires soft water to ensure proper washing results
and is equipped with an internal water softening system. However, if you
have a household water softening system, the internal system provided
is not needed.
For the water softening system to function properly, it will need to use
dishwasher water softening salt. The amount of salt dispensed can be
set from "H:00" to "H:07". Salt is not used at H:00 (default factory set-
ting). The amount of salt required depends on the degree of hardness of
your tap water. See Table 1.
1 Turn the unit on using the ION/OFF] button.
2 Hold down the "A" button (see Figure 1) and press [START] until
the display indicates "H:00".
Release both buttons and press the "C" button to select the
desired setting.
Save the selected setting
by pressing [START].
3
4
|
|
Normal
t
I
e
Express
Table 1;_ Water hardness
0 1 i0 H:O0 No
2:0 _40 H:01 yes
150 - _80 H:G2 yes
90 _ 210 H:03 yes
220 o290 H:04 yes
300 _ 370 H:O5 yes
380 540 H:06 yes
550 - 890 H:07 yes
Figure 1
Using the water hardness test strip
Kurz ein_ud_en PIon:g_xbt_veme_t W
(1s_),le}¢ht a_> (_ see},69outtez
s_hQtte_#ued nach water and compare l_×c#s d'eau et corn-
mi_ aMes_, afte[ _ rain _3rezaprOs 1rain,
E_A ; /_ _5::_ <3"dH7 <&Zg_'el<S.4ff
I'T'IZ] T 17::i >4%{W >5_'e! >Z2ff
>8,4°dHg >I &g_'e£>l$,l 'ff
>14'_dH/>17,9'eh,25,2ff
4 rot!r_/muge II:::m::,::l_:.l:::: >2Y_H/>Z6,Z5°el>:_Z,8°f
AQUADUR®
Test_tabd_en zur _estimmung
tier W_ssed_te
Test stkk fo_ determina_ior_
d _a_ethandless
Bandele[te pou_ d6terminer
[a duret6 de ['eau
[ uuc;_
[ uuu
[ aa=
[ aI_I]
[ m_m]
0 H:00 no
1 H:00 no
2 H:02 yes
3 H:04 yes
4 H::06 yes
To Next Page
Loading...
